Lesson: Using Layers ■ 269
5.
Draw a line on the Center layer across the
center of the object as indicated below:
■ Zoom out so that the entire drawing is
displayed, then zoom into the area shown
below.
■ On the Home tab, click Layers panel >
Layer Control list. Select the Center layer.
■ Start the Line command.
■ Acquire the 180 degree quadrant point of
the large circle and drag your cursor to the
left along the extension path.
■ In the dynamic input field, enter 5. Press
ENTER.
■ Drag your cursor outside the large circle to
the right along the extension path.
■ In the Dynamic Input field, enter 85. Press
ENTER.
■ Press ENTER again to end the Line
command.
6.
To create another line across the center of the
object:
■ Press ENTER to repeat the Line command.
■ Acquire the 270 degree quadrant point
of the large circle and drag your cursor
downward along the extension path.
■ In the Dynamic Input field, enter 5. Press
ENTER.
■ Drag your cursor outside and above the
large circle along the extension path.
■ In the Dynamic Input field, enter 85. Press
ENTER.
■ Press ENTER again to end the Line
command.
Comments to this Manuals