Lesson: Applying a Radius Corner to Two Objects ■ 411
6.
To create a blend between the part profile and
the screw bosses:
■ Start the Fillet command.
■ Right-click anywhere in the drawing area.
Click Multiple.
■ Right-click anywhere in the drawing area.
Click Trim. Click No Trim.
■ Right-click anywhere in the drawing area.
Click Radius.
■ Enter 2. Press ENTER.
■ Select the horizontal line, and then select
the larger circle.
7.
Repeat the selection on the opposite side of
the circle.
The fillet should appear as shown.
8.
To complete the boss creation:
■ Repeat the selection process on the other
bossed areas in the drawing, as indicated
in the following image.
■ Press ENTER to end the Fillet command.
9.
Zoom to display the entire drawing.
10.
To ignore the radius setting and create a sharp
corner while using the fillet command:
■ Start the Fillet command.
■ On the command line, confirm the radius is
still set to 2.0000.
■ Select the horizontal line.
■ Press SHIFT+ select the vertical line to
create a zero-radius fillet.
Comments to this Manuals