Autodesk AUTOSKETCH 8 Service Manual download pdf (Page 34)

Creating a Production Drawing

Creating More Views

You can easily create top, side, and isometric views directly from the front view.

1. On the Panel bar, click the Projected View

tool.

2. Select the front view you just created, and

then click to the right to define the location of

the side view.

A rectangular preview of the view is displayed.

3. Move the cursor below the front view and click

to define the location for the top view.

4. Move the cursor to the lower right (as shown

in the image), and click again to define the

location for an isometric view.

5. To finalize these drawing views, right-click and then choose Create.

Your drawing should now show four different drawing views similar to the image shown above.

Adding a Section View

You can also easily create section views.

1. On the Panel bar, click the Section View tool.

2. To identify the parent view, select the top view (the

view in the lower-left corner).

3. To identify the position of the vertical section line, click

once above and once below the top view.

Tip: When sketching the line, ensure the vertical

constraint | is displayed next to the line before you

click the second point of the line.

4. To finish defining the vertical section line, right-click in the graphics window and choose Continue.

5. To place the section view, click the location between the top view and the isometric view.

You may notice that the section does not go through the center of the top view. You can easily correct this by

dragging the section line left or right. The section view automatically updates after you adjust the location of

the section line.

INV8_TD_Book5.book Page 29 Tuesday, October 28, 2003 10:51 AM

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 82 83

No comments

Autodesk AUTOSKETCH 8 Service Manual Page 34